Connecting Cables - Eizo FlexScan S2031W Setup Manual

Prior to use

Connecting Cables

Attention
• When replacing the current monitor with a S2031W/S2431W monitor, be sure to change the PC settings
for resolution and vertical frequency to those which are available for the S2031W/S2431W monitor
referring to the resolution table (back of cover page) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User's Manual on the CD-ROM.
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
CD player, etc
Connectors on
the PC
Audio output
connector
DVI connector
D-Sub mini 15-pin
connector
3
Plug the power cord into a power outlet and the Power connector on the monitor.
Covering the Monitor Cables
Cover the monitor cables with the cable holder.
Height adjustable stand
4
Installation Setting/Adjustment
Stereo mini jack cable (supplied)
Signal cable FD-C39 (supplied)
Digital connection
Signal cable MD-C87 (supplied)
Analog connection
Cable holder
Troubleshooting
Connectors on
the monitor
Audio input
connector
DVI-I connector
D-Sub mini 15-pin
connector
EZ-UP stand