Configure The Router; Using The Console To Access The Cli - Cisco ASR1002 - ASR 1002 Router Quick Start Manual

#########################################################################################################
##############
#########################################################################################################
############
.
.
.
.
.
.*Feb 13 13:01:34.034: %ASR1000_OIR-2-INSSPA: SPA inserted in subslot
*Feb 13 13:01:34.370: %SYS-5-RESTART: System restarted --
Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version 12.2(33)XNA, RELEASE
SOFTWARE
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Thu 01-May-08 00:29 by mcpre*Feb 13 13:01:36.253: %DYNCMD-7-CMDSET_LOADED: The Dynamic Command
set has been loaded from the Shell Manager
*Feb 13 13:01:36.326: %CRYPTO-6-ISAKMP_ON_OFF: ISAKMP is OFF
Router>
You have the option of proceeding with the setup command facility to configure the interfaces or exiting from setup
Note
and using configuration commands to configure global (system-wide) and interface-specific parameters. You do not
have to configure the interfaces immediately; however, you cannot enable the interfaces or connect them to any
networks until you have configured them. For detailed software configuration information, see the
Series Aggregation Services Routers Software Configuration
8

Configure the Router

Use this section for information on configuring the Cisco ASR 1002-F Router.

Using the Console to Access the CLI

To access the command-line interface using the console, follow these steps:
Your system is booting and if you answer No, at the prompt:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Press Return to enter user EXEC mode. The following prompt appears:
Step 1
Router>
From user EXEC configuration mode, enter the enable command as shown in the following example:
Step 2
Router> enable
At the password prompt, enter your system password. If an enable password has not been set on your system, this step
Step 3
may be skipped. The following example shows entry of the password called enablepass:
Password: enablepass
Step 4 When your enable password is accepted, the privileged EXEC configuration mode prompt appears:
Router#
Step 5 You now have access to the CLI in privileged EXEC mode and you can enter the necessary commands to complete your
desired tasks.
Guide.
Cisco ASR 1000
23