Protocol Configuration Options For Radius - Cisco 2509 - Router - EN User Manual

Protocol Configuration Options for RADIUS

Step 2
Step 3
Step 4
Step 5
Protocol Configuration Options for RADIUS
User Guide for Cisco Secure ACS for Windows Server
3-10
In the TACACS+ Services table, select the check box for each TACACS+ service
you want displayed on the applicable setup page.
To add new services and protocols, follow these steps:
In the New Services section of the TACACS+ Services table, type in any
a.
Service and Protocol to be added.
If you have configured Cisco Secure ACS to interact with device
Note
management applications for other Cisco products, such as a
Management Center for PIX Firewall, Cisco Secure ACS may
display new TACACS+ services as dictated by these device
management applications. To ensure the proper functioning of
Cisco Secure ACS, of device management applications with which
Cisco Secure ACS interacts, and of the Cisco network devices
managed by those applications, do not change or delete automatically
generated TACACS+ service types.
Select the appropriate check box to select those that should be displayed for
b.
configuration either under User Setup, or Group Setup, or both.
In the Advanced Configurations Options section, select the check boxes of the
display options you want to enable.
When you have finished setting TACACS+ interface display options, click
Submit.
Result: The selections made in this procedure determine what TACACS+ options
Cisco Secure ACS displays in other sections of the HTML interface.
It is unlikely that you would want to install every attribute available for every
protocol. Displaying each would make setting up a user or group very
cumbersome. To simplify setup, this section allows you to customize the attributes
that are displayed. For a list of supported RADIUS AV pairs and accounting AV
pairs, see Appendix C, "RADIUS Attributes."
Chapter 3 Setting Up the Cisco Secure ACS HTML Interface
78-14696-01, Version 3.1