Configuring Ascend Radius Settings For A User Group - Cisco 2509 - Router - EN User Manual

Chapter 6 Setting Up and Managing User Groups

Configuring Ascend RADIUS Settings for a User Group

Note
Step 1
Step 2
Step 3
Step 4
Step 5
78-14696-01, Version 3.1
The Ascend RADIUS parameters appear only when both the following are true:
A AAA client has been configured to use RADIUS (Ascend) or RADIUS
•
(Cisco IOS/PIX) in Network Configuration.
Group-level RADIUS (Ascend) attributes have been enabled in Interface
•
Configuration: RADIUS (Ascend).
Ascend RADIUS represents only the Ascend proprietary attributes. You must
configure both the IETF RADIUS and Ascend RADIUS attributes. Proprietary
attributes override IETF attributes.
The default attribute setting displayed for RADIUS is
To hide or display Ascend RADIUS attributes, see
Options for Non-IETF RADIUS Attributes, page
authorization to a particular group persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the group configuration interface.
To configure and enable Ascend RADIUS attributes to be applied as an
authorization for each user in the current group, follow these steps:
Confirm that your IETF RADIUS attributes are configured properly. For more
information about setting IETF RADIUS attributes, see
RADIUS Settings for a User Group, page
In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
From the Jump To list at the top of the page, choose RADIUS (Ascend).
In the Ascend RADIUS Attributes table, determine the attributes to be authorized
for the group by selecting the check box next to the attribute. Be sure to define the
authorization for that attribute in the field next to it. For more information about
attributes, see Appendix C, "RADIUS Attributes,"
documentation.
Configuration-specific User Group Settings
6-37.
User Guide for Cisco Secure ACS for Windows Server
Ascend-Remote-Addr
Setting Protocol Configuration
3-16. A VSA applied as an
Configuring IETF
or your AAA client
.
6-41