Configure The Fast Ethernet Wan Interface; Configure The Atm Wan Interface - Cisco 520-T1 - Small Business Pro SR Secure Router Software Configuration Manual

Chapter 1 Basic Router Configuration
Based on the router you have, configure the WAN interface(s) by using one of the following procedures:
•
•

Configure the Fast Ethernet WAN Interface

This procedure applies only to the Cisco Secure Router 520 Ethernet-to-Ethernet routers. Perform these
steps to configure the Fast Ethernet interface, beginning in global configuration mode:
Command
Step 1 interface type number
Example:
Router(config)# interface fastethernet 4
Router(config-if)#
Step 2
ip address ip-address mask
Example:
Router(config-if)# ip address 192.1.12.2
255.255.255.0
Router(config-if)#
Step 3 no shutdown
Example:
Router(config-if)# no shutdown
Router(config-if)#
Step 4
exit
Example:
Router(config-if)# exit
Router(config)#

Configure the ATM WAN Interface

This procedure applies only to the Cisco Secure Router 520 ADSL-over-POTS and
Cisco Secure Router 520 ADSL-over-ISDN routers.
OL-14210-01
Configure the Fast Ethernet WAN Interface
Configure the ATM WAN Interface
Purpose
Enters the configuration mode for a Fast
Ethernet WAN interface on the router.
Sets the IP address and subnet mask for the
specified Fast Ethernet interface.
Enables the Ethernet interface, changing its
state from administratively down to
administratively up.
Exits configuration mode for the Fast Ethernet
interface and returns to global configuration
mode.
Cisco Secure Router 520 Series Software Configuration Guide
Configuring Basic Parameters
1-5