Changing Configuration Register Settings - Cisco 2612 Hardware Installation Manual

Changing Configuration Register Settings

Table C-1
Bit
Number
10
5, 11, 12 0x0020,
13
14
15
Changing Configuration Register Settings
You might want to modify the value in the configuration register to perform the following tasks:
•
•
•
•
•
You can change the configuration register from either the ROM monitor or the operating system
software. To change the configuration register from the ROM monitor, see the
Commands" section on page
following:
Connect a console terminal to the console port of the router as described in the
Step 1
Console Port" section on page
If you have a terminal with a DB-25 port, use an RJ-45 rollover cable and DB-25 adapter. The
Note
RJ-45-to-DB-25 adapter (Cisco part number 29-0810-01) can be purchased from Cisco.
For information about cable pinouts, refer to the online document
Specifications. This document is available online and on the Cisco Documentation CD-ROM.
Configure your terminal or terminal emulation software for 9600 baud (default), 8 data bits, no parity,
Step 2
and 1 stop bit.
Power on the router.
Step 3
When asked if you would like to enter the initial dialog, answer no:
Step 4
Would you like to enter the initial dialog? [yes]: no
Your router is now in the normal operating mode.
After a few seconds, you see the user EXEC prompt (
Step 5
password to enter privileged EXEC mode:
Cisco 2600 Series Routers Hardware Installation Guide
C-2
Configuration Bit Meanings (continued)
Hexadecimal Meaning
0x0400 IP broadcast with all zeros.
Console line speed.
0x0800, 0x1000
0x2000 Boots default ROM software if the network boot fails.
0x4000 IP broadcasts do not have net numbers.
0x8000 Enables diagnostic messages and ignores the contents
of NVRAM.
Recover a lost password
Change the console data rate
Enable or disable the Break function
Manually boot the operating system using the b command at the ROM monitor prompt
Force the router to automatically boot its system image in flash memory, or boot in accordance with
any boot system commands stored in the router's configuration file in NVRAM
B-7. To change the configuration register from the system software, do the
3-20, using the blue RJ-45 to DB-9 console adapter cable.
Router>
Appendix C Configuration Register
"Configuration Register
"Connecting to the
Cisco Modular Access Router Cable
). Enter the enable command and your
OL-2171-06