Initial Configuration Using Sdm; Initial Configuration Using The Setup Command Facility - Cisco 2612 Hardware Installation Manual

Configuring the Router

Initial Configuration Using SDM

If Cisco Router and Security Device Manager has been installed on your router, the following messages
appear at the end of the startup sequence:
yourname con0 is now available
Press RETURN to get started.
For configuration procedures using SDM, refer to the quick start guide that shipped with your router.
You can also access the
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/26xx_qsg/index.htm

Initial Configuration Using the Setup Command Facility

This section shows how to use the setup command facility to configure a hostname for the router, set
passwords, and configure an interface for communication with the management network. If you see the
following messages at the end of the startup sequence, the setup command facility has been invoked
automatically:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
The setup command facility prompts you for basic information about your router and network, and it
creates an initial configuration file.The prompts vary, depending on your router model, the installed
interface modules, and the software image. The following example and the user entries (in
shown as examples only.
For a description of the interface numbering, see the
If you make a mistake while using the setup command facility, you can exit and run the setup command
Note
facility again. Press Ctrl-C, and enter setup at the privileged EXEC mode prompt (
Step 1 To proceed using the setup command facility, enter yes when the power-up messages have ended.
Would you like to enter the initial configuration dialog? [yes/no]: yes
When the following messages appear, press Return to enter basic management setup:
Step 2
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Cisco 2600 Series Routers Hardware Installation Guide
3-26
Cisco 2600 series routers quick start guides
Chapter 3
online at the following URL:
"Interface Numbering" section on page
Installing the Router
) are
bold
1-9.
).
Router#
OL-2171-06