TRENDnet TL2-E284 User Manual page 86

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
User EXEC Mode
switch>
enable
Privileged EXEC Mode
switch#
configure
terminal
Global Configuration Mode
switch(config)#
User EXEC Mode
Privileged EXEC
Mode
Global
Configuration
Mode
Interface
11-21
disable
exit
ip access-list standard
ip access-list extended
Figure 104 –Relationship of Command Modes
When login the .Switch using privilege level 1 accounts, user will entering User
EXEC Mode automatically. User EXEC mode is used to do the basic operation
such as show commands.
When login the .Switch using privilege level 15 accounts, user will entering
Privileged EXEC Mode automatically. A password is required to enable Privileged
EXEC Mode, default is password.
The Global Configuration Mode is used to configure the global commands which
will take effect to whole system and all interfaces.
The Interface Configuration Mode is used to configure the commands for physical
end
interface
exit
vlan
exit
spanning-tree mst
configuration
exit
mac access-list
extended
exit
exit
exit
class-map
exit
policy-map
exit
class exit
Interface Configuration Mode
switch(config-if)#
Config-vlan Mode
switch(config-vlan)#
MSTP Configuration Mode
switch(config-mst)#
MAC Access List
Configuration Mode
switch(config-ext-macl)#
Standard IP Access List
Configuration Mode
switch(config-std-nacl)#
Extended IP Access List
Configuration Mode
switch(config-EXT-nacl)#
Class-map Configuration Mode
switch(config-cmap)#
Policy-map Configuration Mode
switch(config-pmap)#
Policy-map Class Configuration
Mode
switch(config-pmap-c)#