TRENDnet TEW-659BRV User Manual page 28

TRENDnet User's Guide
4. Click the Channel drop-down list and select a specific wireless channel.
Note: The wireless channel must be the same on all WDS devices.
5. Configure your wireless security. See page 14 on securing your wireless network.
Note: The wireless security must be the same on all WDS devices.
6. Click Save to save the changes.
Note: If you would like to discard the changes, click Undo before you click Save.
7. Click on WDS Setting at the bottom of the page.
8. Next to Wireless Bridging, select Enable to enable WDS.
9. Next to a Remote AP MAC #, enter the MAC address of the other WDS supported
wireless device you are bridging. (e.g. 00:11:22:AA:BB:CC)
10. Click Save to save the changes.
Note: If you would like to discard the changes, click Undo before you click Save. You can
also click Back to return to the main wireless configuration page.
© Copyright 2012 TRENDnet. All Rights Reserved.
For additional TEW-659BRV routers, make sure to disable the DHCP server first on all
additional routers and configure the LAN IP address to be different on each router. You
will connect devices to the LAN ports 1-4 only on all additional routers and the WAN
port is not used. Then, repeat steps 3-8 for additional TEW-659BRV routers you are
bridging.
In the diagram below, the blue color represents the WDS wireless bridged connections
between the routers. The green color represents access point mode connections
between wireless client devices and the routers.
TEW-659BRV
25