TRENDnet TEW-638PAP Quick Installation Manual page 13

5. I do not have a DHCP server or DHCP is disabled on my network and I am
unable to configure the TEW-638PAP. What should I do?
1. Go to the TCP/IP settings on your computer and assign a static IP address on
your computer's network adapter in the subnet of 192.168.10.x. Since the
default IP address of the TEW-638PAP is 192.168.10.100, do not assign a static
IP address of 192.168.10.100 on your computer's network adapter.
2. Open Internet Explorer and enter
6. I followed the Quick Installation Guide and setup a new password. When I log
in to the browser configuration an access error message appears. What should I
do?
The default user name is admin and the default password is admin. When you
log in to the browser configuration for the first time, make sure to enter admin for
user name. Do not leave the user name field blank.
7. How do I configure AP Client mode on the TEW-638PAP?
Please refer to the User Guide. The User Guide is on the provided CD-ROM.
8. The TEW-638PAP does not power on when I plug the device into a Power-Over-
Ethernet switch or splitter. What should I do?
1. Verify that the TEW-638PAP powers up using the provided 12V, 0.5A power
adapter.
2. Power cycle the PoE switch. Unplug power to the switch, wait 15 seconds, then
plug the power back in.
3. Plug the device into a different port on the PoE switch.
4. Try using another Cat-5e cable.
If you still encounter problems or have any questions regarding the TEW-638PAP,
please contact TRENDnet's Technical Support Department.
http://192.168.10.100
11
into the address bar.