TRENDnet TEW-637AP Quick Installation Manual page 10

5. I followed the Quick Installation Guide and setup a new password. When I log
in to the browser configuration an access error message appears. What should I
do?
If the password was changed and you don't remember it, you need to reset the
TEW-637AP. To reset the TEW-637AP, power up the unit and wait 30 seconds for
the unit to boot up. Then take a pin or paper clip and press the reset button for 15
seconds, then let go. The reset button is located on the bottom of the TEW-637AP.
Please note that performing a reset on the TEW-637AP will erase all settings
applied and will revert back to default settings. The default user name is admin
and the default password is admin. When you log in to the browser configuration
for the first time, make sure to enter admin for user name. Do not leave the user
name field blank
LED/Button Color
Green
PWR (Power) LED
N/A
Network Port
Green
Link/Act LEDs
N/A
Green
Wireless LED
N/A
Green
WPS LED
N/A
Power Switch
N/A
(EU Version only)
Reset Button N/A
WPS Button N/A
If you still encounter problems or have any questions regarding the TEW-637AP, please
contact TRENDnet's Technical Support Department.
Sequence Definition
Device is on
Solid
Off Device is off
LAN port connected at 10/20 Mbps or 100/200Mbps
Solid
(Half/Full Duplex)
LAN port data transmitting/receiving 10/20Mbps
Blinking
or 100/200Mbps (Half/Full Duplex)
Off Wireless LAN is on or enabled/Wireless data transmission
Blinking
Wireless LAN is on or enabled/Wireless data transmission
Off Wireless LAN is off or disabled
Solid WPS authentication process complete
Blinking
WPS authentication in process
Off WPS is not activated or disabled
Turns on/off power to the TEW-637AP
N/A
N/A Hold 15 seconds to reset device to factory defaults.
N/A
Hold 3 seconds to activate WPS
8