DirecTV R10 User Manual page 27

Before adding a second program source, see page 10 for Basic Setup instructions.
You may have a rooftop antenna or cable service subscription in addition to your
DIRECTV ® programming subscription. The DIRECTV
that can be used to pass an antenna or cable signal through the DVR and to your TV.
You can connect your antenna or cable signal to the DVR, or directly to the
Antenna/RF In jack on your TV. Whichever method you choose, it's important to
remember that you will not have any DVR service functionality (pausing and rewinding
live TV, setting up recordings, etc.) on cable or antenna channels.
Connect the Coaxial RF cable that carries your antenna or cable signal from the wall to
the RF In jack on the DVR.
Connect a Coaxial RF cable (not supplied) from the DVR's RF Out jack to the RF In
jack on your TV.
Alternately, you can connect the Coaxial RF cable that carries your antenna or cable
signal from the wall directly to your TV.
To watch antenna or cable channels, change your TV's input setting by pressing the
INPUT, SOURCE, or TV/VIDEO button on your TV's remote control until the correct
input is displayed. (If you have trouble changing your TV's input setting, consult your
TV's owner's manual.) Use your TV's remote control to change channels.
While you are watching antenna or cable channels, the DVR will record any programs you
have scheduled on DIRECTV ®
again, press the DIRECTV button on the DVR remote. Then change your TV's input
setting until you see DIRECTV Central.
® DVR has RF In and RF Out jacks
channels. When you want to watch video from your DVR
S e t u p E x a m p l e s
If you connect your DVR to your TV
with a Coaxial RF cable in step
you must set the Channel 3/4 switch on
the back of the DVR. Tune your TV to the
same channel (3 or 4) to view the signal.
1
,
17