Table of Contents
Advertisement
SETTING UP YOUR
DIRECTV SYSTEM
Setting up your new DIRECTV System is much easier than assembling a train set or a bicycle. You
should be watching satellite programming in a very short time!
This chapter provides step-by-step instructions for setting up your DIRECTV System and connecting it
to your television or entertainment system. As you are reading this now, it is assumed that you have
already opened and unpacked the box.
The carton includes the digital satellite receiver itself, an access card (already installed in the digital
satellite receiver behind the door), a remote control (batteries included), cables, and this manual.
Contact your dealer if anything is missing or damaged. Please save all packing materials until the
installation of your system is complete in case anything needs to be returned.
You now need to decide where you want to place the digital satellite receiver. Choose a location near
your TV where the power cord or cables will not be inadvertently disconnected. The location should
also be well ventilated. Do not set electronic components or other objects (including this manual) on
top of the digital satellite receiver or otherwise block its cooling vents.
It is recommended that you have your DIRECTV System professionally installed. This is due to safety
issues, electrical codes, and assurance of a quality installation. If you should choose to perform the
installation yourself, please pay special attention to the precautions in the front of this manual
and refer to the chapter "Installing and Pointing Your Satellite Dish Antenna." You may also
want to obtain the Do-It-Yourself Installation Kit, sold separately.
Installing Remote Control
Batteries
{ XE "Remote control:batteries" } Before the remote control can be used, the supplied batteries need to
Battery installation
be installed. First, unsnap the battery cover from the back of the
remote control. Install each fresh battery as shown, making sure that
the + and - on each battery line up with the marks in the battery
compartment. Next, snap the cover back onto the remote control.
Refer to "Programming Your Remote Control" for setting the codes
to control the devices in your entertainment system.
2
P
2-1
AGE
Advertisement
Table of Contents
