Denon AVR-790 Owner's Manual page 30

ENGLISH
Setting items
Channel Level Test Tone Start : Output test tones.
F L (Front L)/ C (Center)/ FR (Front R)/
Set the volume of the test
SBR z (Surround Back R)/ SBL z (Surround Back L)/ SL (Surround L)/
tone to be the same when it
FHL (Front Height L)/ FHR (Front Height R)/ SW (Subwoofer) : Select
is output from each speaker.
the speaker.
z When the "S.Back" setting (vpage 26) is set to "1sp" , "SB" is
displayed.
• –12.0dB ~ +12.0dB (0.0dB) : Adjust the volume.
• When "Channel Level" is adjusted, the adjusted values are set for
all the surround modes. To adjust the channel level separately for the
different surround modes, use the operation see "Adjust the volume of
the different speakers" (vpage 50).
• Speakers set to "None" in the "Speaker Config. " (vpage 25) settings
are not displayed.
• When o is pressed while the subwoofer volume is set to "–12dB" , the
"Channel Level" setting switches to "OFF" .
• I f output of the test tones begins while the muting mode is set, the
muting mode is canceled.
Default : Reset all channel level settings to factory default.
Y es : Reset to the defaults.
No : Do not reset to the defaults.
Crossover Frequency Crossover : Outputs at below set frequency, each speaker's bass signal
output from the subwoofer.
Outputs at below set
4 0Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
•
frequency, each speaker's
250Hz
bass signal output from the
• Advanced : Set the low frequency signals to be output from the signals
subwoofer. Set this according
of the respective speakers to the subwoofer.
to the low frequency
•
Front / Center / Surround / S.Back / Front Height :
reproduction capabilities of
· 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
the speakers you are using.
250Hz : Set the crossover frequency.
This can be set when
"Speaker Config. " –
"Subwoofer" (vpage
25) is set to "Yes" or
"No" .
Remote control

operation buttons
Setting contents
SR (Surround R)/
Select the speaker.
Displaying the menu
:
: Moves the cursor (Up/Down/Left/Right)
Cancel the menu
Setting items
Crossover Frequency
• Always set the crossover frequency to "80 Hz" . When using small
speakers, however, we recommend setting the crossover frequency
to a higher frequency.
• For speakers set to "Small" , sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• T he speakers that can be set when "Advanced" is selected differ
according to the "Bass Setting" setting (vpage 26).
· When "LFE" is selected, speakers set to "Small" at "Speaker
Config. " (vpage 25) can be set.
· When "LFE+Main" is selected, speakers can be set regardless of
the speaker size setting.
: Decision the setting
Making detailed settings (Manual Setup)
Setting contents
: Return to previous menu