Denon AVR-790 Owner's Manual page 26

ENGLISH
NOTE
Do not change the speaker connections or subwoofer volume, or
speaker locations after making measurements. If changes are neces-
sary, make the changes and use the Audyssey Auto Setup once again
for an updated EQ solution.
• If the result differs from the actual connection status or an error mes-
sage appears, use ui to on-screen display "Retry" and then press
to repeat the measurement.
• If the result still differs from the actual connection status after re-
measurement or the error message still appears, it is possible that
the speakers are not connected properly. Turn the AVR-790 off, check
the speaker connections and repeat the measurement process from
the beginning.
• For instance, If the location or direction of a speaker is altered, the
Audyssey Auto Setup should be performed again to ensure the cor-
rect EQ solution for the new room configuration.

Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup)
Error Messages
If the Audyssey Auto Setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is
displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the Audyssey Auto Setup procedure
over again.
NOTE Be sure to turn the power off before checking the speaker connections.
Error messages (examples)
• Included setup microphone is not connected.
Caution
MultEQ
Microphone:None
F
• Not all speakers could be detected.
or
Speaker :None
• The front L speaker was not properly detected.
Retry
Cancel
[ENT]:Retry
• Too much noise in the room for accurate
Caution
MultEQ measurements to be made.
Ambient noise is
F
too high or
Level is too low. • Speaker or subwoofer sound is too low for
accurate measurements to be made.
Retry
Cancel
[ENT]:Retry
• Displayed speaker could not be detected.
Caution
MultEQ
· The front R speaker were not properly detected.
· Only one channel of the surround speakers was
Front
R :None
detected.
· Sound was output from the R channel when only
Retry
Cancel
one surround back speaker was connected.
Skip
· The surround back, but the surround speaker was
[ ]:Up/Down [ ]:CH
not detected.
• Displayed speaker connected with the polarities
Caution
reversed.
MultEQ
Front
L :Phase
Retry
Cancel
Skip
[ ]:Up/Down [ ]:CH
n To perform the Audyssey Auto Setup procedure again
ui
Press to select "Retry" , then press
n
To cancel Audyssey Auto Setup
Use ui to select "Cancel" , then select "Yes" using
Cause
• Connect the included setup microphone to the
• Check the speaker connections.
• Either turn off any device generating noise or
• Try again when the surroundings are quieter.
• Check the speaker installation and the direction
• Adjust the subwoofer's volume.
• Check the connections of the displayed
• Check the polarities of the displayed speaker.
• For some speakers, this error message may
.
o p .
Measures
SETUP MIC jack on the main unit.
move it away.
in which the speakers are facing.
speaker.
be displayed even if the speaker is properly
connected. If you are sure that the wiring is
ui
correct, press to select "Skip" , then press
.