Installing The Optical Drive - Dell PowerEdge 860 Hardware Owner's Manual

Figure 3-6. Removing and Installing the Optional Optical Drive
1
7
1 interposer board
4 retaining pins (4)
7 hard drive 0

Installing the Optical Drive

CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.
1 Align the optical drive's mounting holes with the retaining pins on the hard drive 0 bracket. See
Figure 3-6.
2 Rotate the drive downward until it snaps into place.
3 Connect the interposer card to the optical drive.
Push the plungers into the captive fastener barrels until they snap into place.
4 Connect the interface and power cables to the optical drive's interposer card.
5 Close the system. See "Closing the System" on page 47.
2
3
2 captive fasteners (2)
5 mounting holes (4)
4
5
6
3 interface cable
6 bracket release lever
Installing System Components
51