Dell PowerVault 725N Information Update page 6

Disconnect the CERC card's cable from the backplane.
6
Remove the plastic insert adjacent to the expansion slots. See Figure 1-4.
7
F i g u r e 1 - 4 .
plastic insert
Grasp the expansion card and carefully pull it away from the riser-card connector.
8
Disconnect the cable from the CERC card.
9
Connect the cable that was supplied with the replacement CERC card to the four
10
connectors on the bottom of the replacement card in the order shown in Figure 1-5.
Route the CERC card's cable between the guide tabs and the side of the chassis as you
11
lower the card into the system. See Figure 1-5.
1-4
Infor m ation Update
R e m o v i n g t h e P l a s t i c I n s e r t
PCI slot 1
PCI slot 2