Dell PowerVault 725N Information Update page 10

Install the replacement converter board:
9
a
b
Install the replacement power supply by inserting the guide pins on the power supply
10
into the guide-pin slots on the chassis, lowering the power supply into the chassis, and
then pushing the power supply toward the front of the system. See Figure 1-7.
F i g u r e 1 - 7 .
power-supply cable
screws (2)
converter
board
chassis guide
pins (2)
hard drive 3
1-8
Infor m ation Update
Align the holes in the board with the guide pins on the bottom of the chassis,
lower the board into the system, and slide the board forward 1 cm (0.5 inch).
Replace the two screws that you removed in step 8.
R e m o v i n g a n d R e p l a c i n g t h e P o w e r S u p p l y
power supply
plastic insert
power-supply
guide pins (2)
guide-pin slots (2)