Routing; Routing--Static Route - D-Link DSL-2640B User Manual

Section 6 - Advanced Setup

Routing

There are three sections under the Routing Page in Advanced Settings.
The Static Route section allows you to manually configure any specific
routes that may be needed. The Default Gateway section allows you to
configure the default gateway used by the WAN interface. The RIP function
allows you to configure RIP (routing information protocol).
Clicking on any of the three buttons(Static Route, Default Gateway, or
RIP), will bring you to its associated page.

Routing--Static Route

The Static Route page can be used to add a routing table (a maximum
of 3 entries can be configured). To proceed, click on Add.
On the Static Route Add page, enter the destination network address,
subnet mask, gateway IP address, and select an available WAN interface.
When complete, click Apply.
D-Link DSL-640B ADSL+ 4-Port Router User Manual 47