Table of Contents
Advertisement
Using the Configuration Menu (continued)
RTS Threshold-
Fragmentation-
DTIM interval-
Authentication-
Open System -
Shared Key -
SSID Broadcast-
Super G Mode-
Disabled-
Super G without
Turbo-
Super G with
Dynamic Turbo-
Super G with
Static Turbo-
Advanced > Performance > 802.11g (Continued)
This value should remain at its default setting of 2346. If incon-
sistent data flow is a problem, only a minor modification should
be made.
This value should also remain at its default setting of 2346. If you
experience a high packet error rate, you may slightly increase
your Fragmentation value within the range of 256-2346. Setting
the Fragmentation value too low may result in poor performance.
(Delivery Traffic Indication Message) 1 is the default setting. A
DTIM is a countdown informing clients of the next window for
listening to broadcast and multicast messages.
Select Open system or Shared Key
The DI-784 will be visible to all devices on the network. This is
the default setting
In this mode, in order to access the DI-784 on the network, the
device must be listed in the MAC Address Control List
Choose Enabled to broadcast the SSID across the network.
All devices on a network must share the same SSID (Service
Set Identifier) to establish communication. Choose Disabled
if you do not wish to broadcast the SSID over the network.
Super G is a group of performance enhancement features that
increase end user application throughput in an 802.11g network.
Super G is backwarsd compatible to standard 802.11g devices.
For top performance, all wirelss devices on the network should
be Super G capable. Select either Disabled, Super G without
Turbo, Super G with Dynamic Turbo, or Super G with Static Turbo.
Standard 802.11g support, no enhanced capabilities.
Capable of Packet Bursting, FastFrames, Compression, and no
Turbo mode.
Capable of Packet Bursting, FastFrames, Compression, and
Dynamic Turbo. This setting is backwards compatible with non-
Turbo (legacy) devices. Dynamic Turbo mode is only enabled
when all nodes on the wireless network is Super G with Dy-
namic Turbo enabled.
Capable of Packet Bursting, FastFrames, Compression, and
Static Turbo. This setting is not backwards compatible with non-
Turbo (legacy) devices. Static turbo mode is always on and is
only enabled when all nodes on the wireless network is Super G
with Static Turbo enabled.
33
Advertisement
Table of Contents
