D-Link AirPlus DI-714P+ Manual page 25

Using the Configuration Menu
Advanced > IP Filter
Disabled IP Filter-
Allow all computers to access the Internet except those listed below-
Select this option to allow computers that are in the list to access the
Internet. All other computers will be denied access to the Internet.
Deny all computers access to the Internet except those listed below-
Select this option to deny computers that are in the list to access the
Internet. All other computers will be allowed access to the Internet.
IP- Enter in the IP address range of the computers that you want the policy to
apply to. If it is only a single computer that you want the policy applied to,
then enter the IP address of that computer in the Start Source IP and leave
the End Source IP blank.
Enter in the port range of the TCP/UDP ports that you want the policy to
Port-
apply to. If it is only a single port that you want the policy applied to, then
enter the port number in the Start Port field and leave the End Port field
blank. If you want to use all the ports, you can leave the port range empty.
Select Always, or input a specific time schedule during which the specific
Schedule-
filter will be enabled
Enabled or Disabled-
After you have input all the IP, Port and Schedule information then clidk
Enabled or Disabled. You can change this setting later by clicking on the
Edit or Delete icon in the list of filters at the bottom of this screen.
Select this option if you do not want to use IP filters.
Use IP (Internet Proto-
col) filters to allow or
deny computers ac-
cess to the Internet
based on their IP ad-
dress. IP filters apply
both to wired comput-
ers connected to one
of the four Ethernet
LAN ports and also to
wireless clients con-
nected wirelessly to
the DI-714P+.
25