Mounting The Switch; Stacking Switches On A Flat Surface - Alcatel OS-6124 Getting Started Manual

The following figure shows the components of this switch system:
10/100 Mbps
RJ-45 Ports
100-240V~ 50-60Hz 2A
DC INPUT
V A
3.3 15
5 3
12 0.7
RPU
Power
Connector
Socket

Mounting the Switch

This switch can be placed directly on your desktop, or mounted in a rack.
Before you start installing the switch, make sure you can provide the right operating
environment, including power requirements, sufficient physical space, and proximity
to other network devices that are to be connected. Verify the following installation
requirements:
• Power requirements: 100 to 240 VAC (± 10%) at 50 to 60 Hz (± 3 Hz). The switch's
power supply automatically adjusts to the input voltage level.
• The switch should be located in a cool dry place, with at least 10 cm (4 in.) of space
on the sides for ventilation.
• Place the switch out of direct sunlight, and away from heat sources or areas with a
high amount of electromagnetic interference.
• If you intend to mount the switch in a rack, make sure you have all the necessary
mounting screws, brackets, bolts and nuts, and the right tools.
• Check if network cables and connectors needed for installation are available.

Stacking Switches on a Flat Surface

The OmniStack ® 6124 can be stacked
anywhere there is enough flat space, such
as on a table or desktop.
1. Stick the self-adhesive rubber foot
pads (that come with this package) on
each of the 4 concave spaces located
on the bottom of the first switch.
2. Place the first switch on a firm flat surface where you want to install the stack.
3. Repeat step 1 for each switch before stacking them. The switch's rubber foot
pads cushion the switch against shock/vibrations and provide space between
each switch for ventilation.
Port Status
Indicators
Indicators
MNGT
Module 2 Module 1
stacking module can be installed in module 2 only
Media or Stacking
Module Slot
Installing the Switch
Module
Mode
Selection
Media
Module Slot
1
1
System
Indicators
1
Management
Module Slot
3