Table of Contents
Advertisement
qinq uplinkport <enable|disable> <LIST>
A port configured to support network end of QinQ tunnel is called a QinQ uplink‐port. Use this command to enable/disabel QinQ
uplinkport to specified port(s).
qinq tunnel add <1‐25> <1‐4094> <LIST>
Add QINQ tunnel.
Parameters:
<1‐25> specifies the tunnel ID
<1‐4094> specifies the VLAN ID
<LIST> specifies the ports to be set to QINQ tunnel.
qinq tunnel delete <1‐25>
Delete QinQ tunnel.
Parameters:
<1‐25> specifies the tunnel ID
show qinq configuration
Show QinQ global and portal configuration
show qinq tunnel
Show QinQ tunnel information
For example, refer to the figure of QinQ application in previous page, a QinQ tunnel using VLAN10 wants to be created for Sales
VLAN100 across the public network. Port1 on left‐side switch connects to Sales VLAN100 client. Port16 of switch connects to the
public network. The following commands needs to be set:
qinq enable
qinq tpid 8100
qinq userport enable 1
qinq uplinkport enable 16
qinq tunnel add 1 10 1,16
Advertisement
Table of Contents
