Turning Off The Projector - Canon ReallS SX80 User Manual

Turning Off the Projector

1
Press the POWER button to pop up a window shown at the lower right.
Remote control
Press the POWER button again while the confirmation message is displayed.
The lamp goes off, the [POWER] indicator starts flashing in red and the cooling fan
starts.
• You cannot turn the projector on while the cooling fan is in operation.
If you want to continue projecting, press a button other than POWER or wait until the con-
firmation message disappears.
• You may shorten the lamp life if turning off the projector while its lamp is still in an unstable
state shortly after turning on the projector. Wait at least 5 minutes before turning off the pro-
jector. It may shorten the lamp life if you turn on the projector immediately after turning it off.
• Wait at least 5 minutes before turning on the projector when you turn off the projector.
• Using the projector for a long time may shorten the life of the lamp and internal optical
components.
2
Remove the power cord from the AC outlet.
It continues to cool down the lamp even after removing the power cord. Thus, you
may carry it immediately after the use.
With the power cord connected, the LED illumination lamp turns on during cooling
cycle.
• Wait until the cooling fan stops before putting the projector in the carrying bag. Do not put
the projector in the carrying bag until the cooling fan stops rotating. The projector may be
damaged due to the heat.
• Attach the lens cap to the lens to protect it and put the projector in the carrying bag.
Top control
61