Table of Contents
Advertisement
BASIC OPERATION
TO TURN ON THE PROJECTOR
Connect the projector to a source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the appropriate
terminals on the rear of the projector. (See "CONNECTING THE PROJECTOR" section on pages 11-18).
Connect the projector's AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the rear of the
projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will light GREEN.
Press the POWER button on the remote control unit or on the projector to ON. The
LAMP POWER indicator light will dim and the cooling fans will operate. The wait
display appears on the screen and the count-down starts (30-29-28-...1). The signal
from the source appears after 30 seconds.
CAUTION:
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES
BEFORE TURNING IT OFF.
NOTE: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.
Wait at least 5 minutes before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continued to flash, follow the procedures below:
(1). Press POWER button to OFF.
(2). Check the air filter for dust accumulation.
(3). Remove dust with vacuum cleaner. (See "AIR FILTER CARE AND CLEANING" section on page 49).
(4). Press POWER button to ON.
If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or service
station.
TO TURN OFF THE PROJECTOR
Press the POWER button on the remote control unit or on the projector. The "Power
off ?'' appears on the screen. Press again the POWER button to turn OFF the
projector. The LAMP POWER indicator will light bright and READY indicator will turn
off. The cooling fans will operate for approximate 2 minutes after the projector is
turned off. (During this "cooling down" period, the projector cannot be turned on).
The READY indicator will light green again and the projector may be turned on by
pressing the POWER button. To power off completely, turn the MAIN ON/OFF
switch (located on the rear of the projector) to the OFF position.
MODE SELECT
Press the MODE button on the projector or the COMPUTER and
VIDEO button on the remote control unit to select Computer 1,
Computer 2, Video Input. The "Computer 1", "Computer 2" or "Video"
display will appear on the screen for a few seconds.
TURNING ON/OFF THE PROJECTOR
DIRECT OPERATION
MODE button
COMPUTER button
Computer 1
Computer 2
VIDEO button
Video
30
Computer 1
Computer 2
Video
27
Advertisement
Table of Contents
