Auto Needle Threading Device - Brother PE-150V User Manual

1
4
3
2

Auto needle threading device

Net
If using special threads which wind quickly off the
thread spool, attach a net to the spool before using.
* Cut the net to match the size of the spool.
1 Net
2 Thread spool
4 3 Spool pin
4 Spool cap
1. Guide the thread through the wire loop thread
6
guide (number "6") and gently pull the thread
towards you.
2. Lower the presser foot.
3. Lower the needle threader lever until it stops.
Hook the thread into the guide and pull it
across to the right.
1 Wire loop thread guide
2 Needle threader lever
3 Guide
* The needle threading device cannot be used
while the needle is lowered.
4. Push the needle threader lever toward the back.
Check to be sure that the hook has passed
through the eye of the needle and route the
thread under the metal guides and the hook.
* Pull the thread toward you and check that it is
being held by the thread hook.
1 Hook
2 Metal guides
3 Thread correctly under the metal guides and
the hook.
5. While gently holding the thread, pull the
needle threader lever forward.
6. Release the thread from the needle threader
lever.
7. Pull the upper thread through the needle eye
toward the rear of the machine.
17