Troubleshooting Of Minor Faults - Bosch Nexxt WFMC3200UC Operating & Installation Instructions Manual

Troubleshooting of Minor Faults

d
DANGER!
Fault
The door cannot be
opened.
Door cannot be opened,
even though the
appliance has been
switched off and on
again.
Control lights do not light g g
up.
Program does not start.
Start/Pause indicator
light flashes.
Program does not start.
Indicator light end" is lit Indicator light end" is lit
and display is flashing
E:01"
Spin speed cannot be
selected.
24
d
q
Off
q
q
q
Possible cause
No final spin" selected.
Power failure.
Program is running and/or the door is locked for
safety reasons.
Plug is loose or not inserted.
Program selector turned to Off before end of
program.
For safety reasons the door has been locked because
the water level, temperature or speed is too high.
A fuse has blown.
Power failure.
Start/Pause button not pressed.
Door not closed properly.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Program selector is set to Drain; spin cycle is not
possible with this program.
Action
Select Drain or Spin.
An interrupted program will be resumed when power
is restored. If the laundry is to be removed during
a power failure, Customer Service
(refer to Page 26).
Wait until the program ends; see Page 21.
Eliminate the cause.
Select a program.
See "Add a garment/Interrupting the program",
Page 21.
Replace the fuse of the individual circuit.
Call Customer Service if this fault recurs.
An interrupted program will be resumed when power
is restored. If the laundry is to be removed during a
power failure, Customer Service
(refer to Page 26).
Press the Start/Pause button.
Check whether laundry is trapped in door.
Close the door (a click should be heard).
Program continues.
Select speed before spinning.
If required, select another program.