Troubleshooting Of Minor Faults - Bosch Nexxt 100 Series WFMC1001UC Operating, Care And Installation Instructions Manual

Troubleshooting of Minor Faults

d WARNING
TO AVOID RISK OF ELECTRIC
SHOCK!
Repairs should only be carried out
by an authorized technician.
Fault
The door cannot be
opened.
Door cannot be opened,
even though the appliance
has been switched off and
on again.
Control lights do not light Control lights do not light
up. up.
Program does not start.
Start/Pause indicator light
flashes.
Program does not start. Program does not start.
Indicator light end" is lit. Indicator light end" is lit.
Detergent residue in the Detergent residue in the
detergent dispenser. detergent dispenser.
Water does not enter the
machine or detergent is not machine or detergent is not
washed away. washed away.
Indicator light spin" is lit. Indicator light spin" is lit.
Water cannot be seen in
drum.
Indicator light rinse" is lit
with no water remaining in
tub.
Water is flowing out from Water is flowing out from
underneath the machine. underneath the machine.
If repairs are necessary, and you
d
cannot eliminate the fault yourself with
the aid of the following table:
Possible cause
Power failure.
Program is running and/or the door is locked for safety
reasons.
Plug is loose or not inserted.
Program selector turned to Off before end of program.
For safety reasons the door has been locked because the
water level, temperature or speed is too high.
A fuse has blown. A fuse has blown.
Power failure.
Start/Pause button not pressed.
Door not closed properly. Door not closed properly.
Detergent was damp or lumpy. Detergent was damp or lumpy.
Water tap(s) not turned on.
Supply hose kinked or pinched.
Strainers in supply hose clogged.
Water pressure too low.
This is not a fault.
The water level is below the visible part of the drum.
Suds or pump is blocked.
The thread of the supply hose is not tight.
Leak in the drain hose.
Turn the program selector to Off.
q
Disconnect the washing machine
q
from the power outlet.
Turn off the water taps.
q
Call Customer Service
q
(refer to Page 25).
Action
An interrupted program will be resumed when power is
restored. If the laundry is to be removed during a power
failure, call Customer Service
(refer to Page 25).
Wait until the program ends; see Page 20.
Eliminate the cause.
Select a program.
See "Add a garment/Interrupting the program", Page 20.
Replace the fuse of the individual circuit.
Call Customer Service if this fault recurs.
An interrupted program will be resumed when power is
restored. If the laundry is to be removed during a power
failure, call Customer Service
(refer to Page 25).
Press the Start/Pause button.
Check whether laundry is trapped in door.
Close the door (a click should be heard).
Program continues.
Clean and dry the detergent dispenser; see Page 21.
Use the cap of the detergent bottle to measure liquid
detergents.
Turn on water tap(s) and press Start/Pause button.
Program continues.
Eliminate the cause.
Clean the water inlet strainers; see Page 21.
Eliminate the cause.
Use less detergent for future wash loads. Detergents
specifically designed for you High Efficientcy washer pro
duce fewer suds and will include the letters HE" on the
packaging. Clean the water drainage pipe and/or drain
hose. Turn the program selector to off" and restart Drain
program.
Tighten the thread.
Replace the drain hose.
23