Adjustment Procedure For Dolby Surround; Setting The Speakers - Alpine IVA-D105 Owner's Manual

Adjustment Procedure for Dolby
Surround
Make the adjustments described below in order to reproduce Dolby
Digital and DTS sound with greater accuracy.
Adjustment procedure
1
Speaker Setup (page 48)
(Turning the speakers to be used on and off and
setting their response)
2
Adjusting the speaker levels (page 49)
(Adjusting the signal output level to the various
speakers)
3 Mixing bass sound to the rear channel
(page 49)
(Achieving smooth sound in the rear seat by mixing
the front audio signals with the rear speaker signals)
4
Adjusting the acoustic image (page 49)
(Adjusting the acoustic image to achieve a sound as
if the centre speaker were directly in front of the
listener)
5
Achieving powerful high volume sound
(page 49)
(Achieving energetic sound with even greater power,
like the sound in a movie theater)
6
Adjusting the DVD Level (page 50)
(Adjust the volume (signal level) in the Dolby Digital,
Pro Logic II, DTS and PCM modes.)
Storing Settings in the Memory (page 50)
7
(Storing all the settings and adjustments made on the
IVA-D105 (not only the above settings/adjusts) in the
memory)
In case of combining the Automatic adjustments, etc.
We recommend to make the Automatic adjustments before the Dolby
Surround adjustments.
44
-EN
: the following settings can be made for an external audio
processor.
Following Steps 1 to 5 describe the common procedures for
operating the Audio Processor setting function. For details of
the setting function items, refer to descriptions of respective
items.
1
Check the Defeat mode is off (page 27), and then
touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [ ] of AUDIO.
The AUDIO setup screen appears.
3
Touch [ ] of A.PROCESSOR.
The A.PROCESSOR list screen appears.
4
Touch [ ] [ ] or [
change its setting.
Setting items :
X-OVER / T.CORR / PHASE / G-EQ / P-EQ / MEDIA XPANDER /
BASS SOUND CONT. / DOLBY PLII /REAR FILL / SPEAKER
SELECT / MULTI CH SETUP / SPEAKER SETUP / DVD LEVEL /
PCM MODE / USER PRESET
5
Touch [RETURN] to return to the previous screen.

Setting the Speakers

Setting item : SPEAKER SELECT
Set the connected speaker by touching the respective
[ ] or [ ] button.
BassEngine
FRONT: ON Fixed
REAR: OFF/ON
CENTER: OFF/ON
SUBW.: OFF/ON
A.PROCESSOR
FRONT1: OFF/FULL (Full Range)/TW (Tweeter)
FRONT2: OFF/ON
REAR: OFF/ON
CENTER: OFF/ON
SUBW.: OFF/MONO/STEREO
• Set the speaker which is not connected to OFF.
• Settings above can be carried out even when the speaker is set to
OFF in "Speaker Setup" (page 48).
• To use the subwoofer in MONO with PXA-H700 or PXA-H701
connected, connect the subwoofer to the subwoofer output terminal
of PXA-H700 or PXA-H701.
] of the desired item to