Troubleshooting - Haier LT19M1CW User Manual

TROUBLESHOOTING

The following table contains common problems and the solutions to these problems.
Please check this list before you contact technicians.
Problems
No picture
Abnormal colours
Twisted picture
Picture too dark
Audio only, no images
Picture only, no audio
Cannot use remote control
Cannot receive sufficient
channels through antenna
No colours
Blinking picture accompanied by
ghost image
Broken lines or segments
Certain TV channels are blocked
(Hope to acquire some channels)
Overlapping images or ghost
images
Cannot use a function
Cannot receive programs
36
Sloutions
1. Connect power cord correctly.
2. Turn on power.
3. Connect signal cable correctly.
4. Press any button on the LCD TV.
Connect signal cable correctly.
1. Connect signal cable correctly.
2. Please use compatible signal.
Adjust brightness and contrast.
Audio only, no images
1. Please check if input signal is connected correctly.
2. TV-RF signal must not be lower than 50dB.
1. Connect signal cable correctly.
2. Adjust volume to proper level.
3. Connect audio signal cable correctly.
4. TV-RF signal must not be lower than 50dB.
1. Please change battery.
2. Turn off power for 10 seconds; and then restart power.
Please use the Channel scan function to increase the number
of channels not included in memory.
Please adjust the colour setup.
1. Check the connection of antenna/signal cable.
2. Check if channel is in play mode.
3. Press signal source and change input mode.
Adjust antenna.
Keep the TV away from noise sources, such as vehicles, neon
lights, and hair dryers.
Please use the Update scan method to add the channels not
included in memory.
Please use multi-directional outdoor antenna. (If your TV is
subject to the influence of nearby mountains or buildings).
If the item you choose turns grey, that item cannot be selected.
Please use the Update scan method to add the channels not
included in memory.
HD Ready Digital LCDTV User Manual