Troubleshooting; Warranty - Haier HL19SL2 Owner's Manual

Operating
Temperature Range
Operating Humidity
Range
Maximum Elevation
Accessories
* The specifications shown above may be changed
without prior notice for quality improvement.

Troubleshooting

Troubleshooting
For the sake of time and cost, it is strongly
recommended that you check out the problem
by yourself according to the instructions listed
hereunder before contacting the after-sales service
for technical assistance.
No picture,
no sound
Blank screen
No sound
Poor sound
Downloaded from www.Manualslib.com
32~104 0F (0~40 0C)
Less than 80%
6561 feet (2000m)
Remote control
Batteries
User manual
Quick start guide
Verify if the television is properly
plugged.
Verify if the television is properly
supplied power.
Verify if electricity is available.
Verify if correct signals are input.
Press INPUT button to change
signal input to TV input.
Restart the television of power
supply is interrupted.
Press Mute button and verify if
Mute mode is set.
Switch to other channel and verify
if the same problem happens.
Press VOL+ button to see if the
problem can be solved.
Verify if sound system is correct.
Refer to Page 18 for adjustments.
manuals search engine
Troubleshooting / Warranty
Verify if correct channel is selected.
No picture
Adjust the antenna.
in some
Make adjustments by Fine Tune
channel
and Manual Scan.
No color Verify if the same problem exists in
other channels.
for some
Check out of picture and sound
channel
systems.
program
(black and Refer to relative instructions in the
Manual for color adjust.
white)
Verify if the antenna is correctly
Spots with connected.
Verify if the antenna is in good
some or all
condition.
pictures
Make fine adjustment of channel.
Horizontal/
Check for local interference such
vertical bars
as an electrical appliance or power
or picture
tool.
shaking
Disconnect the television from
power supply and, 10 seconds
later, connect the television to
Television
the power supply. If the problem
out of control
still exists, contact authorized
after-sales service for technical
assistance.
Note
Do not leave the television with static picture in
an extended period as the image may become
permanently burned.
Note
The TV set must only be repaired by a qualified
registered service person. Never attempt to remove
the back cover as the TV set has dangerous voltages
levels inside that may be fatal or cause fire.

Warranty

Warranty
This Haier brand product, when shipped in its original
container, will be free from defective workmanship and
materials, and agrees that it will, at its option, either repair
the defect or replace the defective product with a new or
remanufactured equivalent at to the purchaser, for parts
Haier LED HDTV EN-22