Table of Contents
Advertisement
Bridged Connection for WAN
Home > WAN > Bridge Mode
For Bridged connections
it will be necessary for
most users to install
additional software on
any computer that will
the Router for Internet
access. The additional
software is used for the
purpose of identifying
and verifying your
account, and then
granting Internet access
to the computer
requesting the
connection. The
connection software
requires the user to enter
the User Name and
Password for the ISP
account. This information
is stored on the
computer, not in the
Router.
Follow the instructions
below to configure a
Bridged connection for
the WAN interface.
To configure a Dynamic IP Address connection, perform the steps listed below. Some
of the settings do not need to be changed the first time the device is set up, but can
be changed later if you choose. See the table below for a description of all the
settings available in this menu.
1. Choose the Bridge Mode option from the WAN Settings pull-down menu.
2. Under the ATM VC Settings at the top of the menu should not be changed
unless you have been instructed to change them. However, if you are
instructed to change the VPI or VCI values, type in the values assigned for
your account. Leave the PVC and Virtual Circuit setting at the default (Pcv0
and Enabled) values for now. This can be used later if you are configuring
multiple virtual circuits for your ADSL service. For more information on ATM
VC Settings, see the table on page 31 below.
3. Under the Bridge Mode heading, choose the Connection Type from the
pull-down menu. This defines both the connection type and encapsulation
DVA-G3340S User Manual
WAN Settings Menu – Bridge Mode
Page 24 of 94
V1.00 AU
Advertisement
Table of Contents
