If A Matrix Channel Is Selected - Yamaha LS9-16 Owner's Manual

If a MATRIX channel is selected

❏ CHANNEL SELECT (Channel selection)
Except for the fact that your editing applies to a MATRIX channel, this is the same as the channel selection for a
MIX channel (➥ p.37).
❏ FROM MIX, ST/MONO
A
FROM MIX, ST/MONO send level
These adjust the send levels of the signals sent from the VARI type MIX buses or STEREO/MONO buses to the
MATRIX bus. The current value is shown in the numerical box immediately below.
• PRE/POST
These select either PRE or POST as the position from which the signal is sent from the MIX buses or STEREO/
MONO buses to the MATRIX bus. PRE POINT is selected if this is on, or POST FADER is selected if this is off.
B ON(FROM MIX, ST/MONO send on/off)
These are on/off switches for the signal sent from the MIX buses or STEREO/MONO buses to the MATRIX bus.
HINT
• If MIX buses and MATRIX buses are being used in stereo, the
odd-numbered knob will be PAN.
• If the FIXED type is selected for the MIX bus, only the ON but-
ton is valid.
• The stereo/mono setting and the VARI type / FIXED type setting can be made in the Mixer Setup screen.
PAN (odd-numbered side)
41 LS9 Editor Owner's Manual