Aip/Vc Layer + Bacteria-Killing Medium Sets - Haier HSU-09H03/R - annexe 2 Operation Manual

Maintenance
The installation and cleanout AIP layer, VC layer + Bacteria-killing medium sets
1.Open the lnlet Grille
The inlet grill is supported by its top
plate at the right side.
2.Detach the standard air filter
Push up the filter's center tab slightly
until it is released from the stopper, and
remove the filter downward.
3.Take the VC layer + Bacteria-killing
medium sets
Take out Take the VC layer or the Bacteria-killing
medium sets from the filter. Push the bottom frame
of AIP layer, and push up the handle at the same
time in order take out the AIP layer board in turns.
4. The installation of AIP layer,VC layer + Bacteria-killing medium sets
(must be installed)
5.Close the Inlet Grille
Put down the inlet grill's top plate, and close the inlet grill.
Common sense:
In order to keep the AIP layer having a highly work effect ,it should be cleaned regularly or
aperiodically just according to the working environment.
1. Turn off the A/C electricity supply and make sure that AIP layer is not working.Then clean the
AIP layer after turning off it five minutes later.
2. Please brush off the dust on AIP board,then steep it into cleaning agent water and wash it.
3. After cleaning AIP board pleas put it on a dry place until it is totally dry.
4. Ensure AIP board is dry enough then install it in the its position along the slide way .
Make sure it is as before and could work well.
The AIP layer will be replaced in fixed time. In normal family, it will be replaced every 6 months.
In the use, please note to clean the filter frequently (take off the back suction cleaner or lightly pat it)
to avoid the operating effect is lowered due to the dust covering the filter. AIP layer and bacteria-killing
medium filter is strictly prohibited from being cleaned by water.
The the bacteria-killing medium filter not in use should be stored in shade, cool and dry place.
Please don't expose it to the sunlight for a long time otherwise the degerming performance will drop.
inlet grill's top plate
AIP(air ionization purify)
(bottom frame)
(AIP board)
Note:the green aspect of the bacteria-killing
medium air purifying filter will face outside, the
white aspect will face to the machine. The
yellow aspect of the VC layer will face outside,
the white aspect will face to the machine.
(Handle)