Auto Operation - Haier HSU-09H03/R - annexe 2 Operation Manual

Operation
Display board
Remote controller
5
4
PURIFY
FRESH
HUMIDITY
POWER/SOFT
TEMP./HUMIDITY DISPLAY
1. Unit start
Press ON/OFF on the remote controller, unit starts.
2.Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
Select Auto operation
Then
3.Select temp.setting
Press TEMP. button
Every time the button is pressed, temp.setting
o
increase 1 C,if kept depressed, it will increase
rapidly.
Every time the button is pressed, temp.setting
o
decrease 1 C,if kept depressed, it will decrease
rapidly.
Select a desired temperature.
4.Fan speed selection
Press FAN button. For each press, fan speed changes
as follows:
Remote controller:
Air conditioner is running under displayed fan speed.
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
5.Unit stop
Press ON/OFF button, the unit stops.
About Auto Operation
Under the mode of auto operation, air conditioner will automatically
select Cool or Fan operation according to room temperature.

Auto Operation

AUTO COOL DRY
LOW
MED HI
FAN HEAT
AUTO