Childproof Lock; Inlet Water Filters; Draining Any Remaining Water And Cleaning The Pump Filter; Maintenance And Cleaning - Beko WMB 61042 PT Manual

The Standby symbol which indicates the machine
is in standby mode lights up and the start symbol
that shows the program has started and is still
continuing fades out.
Selecting or canceling an auxiliary function in
pause mode
Auxiliary functions can be cancelled or selected in
accordance with the step the program is at.
Adding/removing laundry in pause mode
The door can be opened if the water level is
suitable. The door locked symbol will light up until
the door is suitable for opening. This symbol will
fade out as soon as the door is allowed to open.
Laundry may be added / taken out by opening the
door.
Door lock
The Door Locked Symbol lights up when the
loading door is locked. This symbol will flash until
the door is allowed to open. Do not force the door
at this stage. This symbol will fade out as soon as
the door is allowed to open. You may open the
door after the symbol fades out.
Child-proof lock
Protect the appliance from being tampered by
children by means of the child-proof lock. In this
case, no change can be made in the running
program.
Your machine can be turned on and off with
C
On/Off button while the child-proof lock is
activated. In this case, your machine will
resume its program with child-proof lock
activated.
The machine is switched to child-lock by pressing
the 2nd and 4th auxiliary functions for 3 sec.
"C:on" (Child-proof lock is activated) label appears
on the display.
The same symbol will also be displayed whenever
any button is pressed while the machine is child-
locked.
To deactivate the child-proof lock, press the 2nd
and 4th auxiliary function buttons for 3 sec.
"C:OFF" (Child-proof lock is deactivated) label
appears on the screen.
Ending the program through canceling
"Start/Pause/Cancel" button is pressed for 3
seconds to cancel the program. Start symbol will
flash during cancellation. After cancellation, the
symbol of the corresponding step at which the
cancellation was made will remain lit and "End" will
appear on the screen.
End of program
When the program is finished, the symbols of the
relevant steps will remain lit up and the auxiliary
function, spin and temperature data selected at
the start-up of the program will remain selected.
"End" will appear on the display.

5 Maintenance and cleaning

Detergent Drawer

Remove any powder residue buildup in the drawer.
To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
If more than a normal amount of water
C
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the siphon
with plenty of lukewarm water in a washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.

Inlet water filters

There is a filter at the end of each water intake
valve at the back side of the machine and also at
the end of each water intake hose where they are
connected to the tap. These filters prevent the
foreign substances and dirt in the water to enter
into the machine. Filters should be cleaned as they
get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses to
clean the surfaces of the filters on the water
intake valves with an appropriate brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
Draining any remaining water and
cleaning the pump filter
Your product is equipped with a filter system which
ensures a cleaner water discharge that extends
10 - EN