D-Link DCS-6620G User Manual page 60

DCS-6620G User's Manual
Configuration > Tools > Applications (continued)
Weekly schedule
Sunday through Saturday:
All of the time except for
Event operation
Delay second(s) before
Take snapshots at second(s)
D-Link Systems, Inc.
Select the weekdays that should perform the following
operations:
Snapshots begin at:
Set the time to start operations. Setting the begin time
the same as the stop time will force the operations to run
continuously.
Snapshots stop at:
Sets the time to stop the operations.
If you do not wish to set a schedule, this box must be
the above schedule:
checked.
Sets the time delay before restarting to check the trigger
detecting next event:
condition when the current condition is triggered.
After a snapshot is taken because of a trigger, another
after event:
snapshot will be taken after the configured time in
seconds.
Trigger condition:
There are 4 conditions related to the digital input and
three windows for motion detection. There can be multiple
selections. Select the appropriate digital input condition
according to the characteristics of the external device.
"High", "low" indicate external voltage input for level trigger,
while "rising", "falling" is for edge triggers. There are three
windows shown for the names you defined for motion
detection. "Undefined" will show instead of the window
title if motion detection is not setup yet. An active, named
motion window must be checked for motion detection to
be possible.
Reset output:
Check and save this option to reset the external device at
the digital output back to the original state.
Using the DCS-6620G with an Internet Browser
60