Function Rename - Pioneer VSX-9300TX Operating Instructions Manual

Advanced setup
11
3 Select the component that corresponds with the
one you connected to that input
Select between DVD/LD, TV/SAT, VCR1, VCR 2, CD,
CD-R or MD.
• Use the
do this.
• If you assign a digital input to a certain function (for
example, DVD/LD) then any digital inputs previously
assigned to that function will automatically be
switched off.
4 When you're finished, select 'Exit'.
You will return to the Input Assign menu.
Assigning the component video inputs
• Default settings:
Component-1 – OFF
Component-2 – OFF
If you used component video cables to connect your
video equipment you must tell the receiver which device
it is, or else you may see the S-video or composite video
input instead of the component video signal.
1 Select 'Component-In Select' from the Input
Assign menu.
3. Input Assign
[Digital-In Select
[Component-In Select
[Exit
2 Select the number of the component video input
to which you've connected your video component.
The numbers correspond with the numbers beside the
inputs on the back of the receiver.
3 Select the component that corresponds with the
one you connected to that input.
• Use the
do this.
• If you connect any source component to the receiver
using a component video input, you should also have
your TV connected to this receiver's component video
MONITOR output.
4 When you're finished, select 'Exit'.
You will return to the Input Assign menu.
76
En
(cursor up/down) buttons and ENTER to
Component - In Select
Component - 1 [
Component - 2 [
]
[ Exit ]
]
]
Component - In Select
Component - 1 [ DVD/LD ]
Component - 2 [ OFF ]
[ Exit ]
(cursor up/down) buttons and ENTER to

Function Rename

You can customize the names that appears on the
display when you select an input source (for example,
you could change the name of VCR1/DVR to DVR-310).
Tip
• It's convenient to use the front panel controls when
editing names. However, if you want to use the
remote, you can press and hold
characters quickly.
1 Select 'Function Rename' from the System Setup
menu.
OFF ]
OFF ]
2 Select the name of the input you want to
rename.
3 Edit the name as necessary, then press ENTER
repeatedly to set the name and move to the
following line.
to change
System Setup
[ 1. Surround Setup ]
[ 2. THX CINEMA Setup ]
[ 3. Input Assign ]
[ 4. Function Rename ]
[ 5. PHONO/LINE Setup ]
[ 6. Multi Room ]
[ 7. 12V Trigger ]
[ Exit ]
DVD/LD [ DVD/LD ]
TV/SAT [ TV/SAT ]
VCR1/DVR [ VCR1/DVR ]
VCR2 [ VCR2 ]
VIDEO [ VIDEO ]
PHONO/LINE [ PHONO ]
CD [ CD ]
CD-R/TAPE1 [ CD-R/TAPE1 ]
MD/TAPE2 [ MD/TAPE2 ]
USB [ USB ]
[ Exit ]
DVD/LD [ DVD/LD ]
TV/SAT [ TV/SAT ]
VCR1/DVR [ VCR1/DVR ]
VCR2 [ VCR2 ]
VIDEO [ VIDEO ]
PHONO/LINE [ PHONO ]
CD [ CD ]
CD-R/TAPE1 [ CD-R/TAPE1 ]
MD/TAPE2 [ MD/TAPE2 ]
USB [ USB ]
[ Exit ]