Air Conditioner Use; Starting Your Air Conditioner - Haier HWR05XCK Use And Care Manual

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■
If you turn off the air conditioner, wait at least 3 minutes before
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.
1. Remove the clear plastic film from the control panel.
2. Press POWER to turn on the air conditioner. The Power
indicator light will turn on.
NOTE: When the air conditioner is plugged in, the LED display
will show "88" for 3 seconds. After the air conditioner is turned
on for the first time, the display will show the current room
temperature and the fan is set to Low speed.
After the unit is plugged in, but before the unit is turned on,
press and hold the POWER button for 5 seconds to switch
the temperature display between Fahrenheit (F)and
Celsius(C) degrees.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."

AIR CONDITIONER USE

■ Do not try to operate your air conditioner in the Cool mode when
outside temperature is below 61°F (16°C). The inside evaporator
coil will freeze up, and the air conditioner will not operate
properly.

Starting Your Air Conditioner

Mode
1. Press MODE until you see the indicator light glow for the
2. Choose Fan, Cool.
Fan Speed
1. Press FAN SPEED until you see the indicator light glow for
2. Choose High or Low.
desired setting.
■
Fan—Only the fan runs. Press SPEED to select High
or Low fan speed. The display shows the current room
temperature.
■ Cool—Cools the room. Press SPEED to select High or Low
fan speed. Press the TEMP/TIME up or down arrow button
to adjust the temperature.
the desired setting.
■ High—for maximum cooling
■ Low—for minimum cooling
9