Installation - Belkin F5U508 User Manual

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 5
Please refer to the section that corresponds to your version
of the Windows operating system.
Installation Procedure for Windows 98 SE
This installation procedure will successfully install two USB 1.1
OHCI controllers, one USB 2.0 EHCI host controller, and one
IEEE 1394 host controller.
1. Insert the F5U508 installation CD into your CD-ROM drive.
After a few moments the main menu will auto-start and
display each of the available installation options.
2. Select "Install USB 2.0 Driver". After the driver is installed
select "No, I will restart my computer later". Select "Close".
Then select "Exit".
3. Open the Start menu in the lower left hand corner of your
Windows display, then select "Shut Down" and click "OK".
4. Once the computer has completely shut down, remove the
computer's cover and locate an empty PCI slot.
5. Remove the port cover that corresponds with the PCI slot
you wish to use. (The cover is usually held in place with a
single screw).
6. Insert the PCI Card into the slot. Apply pressure as needed
until the card is fully seated. Secure the PCI card with the
screw removed in step #5, above.
7. After installing the PCI Card, replace the outer cover and
turn on the computer.

Installation

5
En