Cpu Configuration - ASROCK P45X3 DELUXE - V1.0 User Manual

this tool and save the new BIOS file to your USB flash drive, floppy disk or
hard drive, then you can update your BIOS only in a few clicks without
preparing an additional floppy diskette or other complicated flash utility.
Please be noted that the USB flash drive or hard drive must use FAT32/16/
12 file system. If you execute ASRock Instant Flash utility, the utility will
show the BIOS files and their respective information. Select the proper
BIOS file to update your BIOS, and reboot your system after BIOS update
process completes.
3.4 3.4 Advanced Screen Advanced Screen
3.4 3.4 3.4 Advanced Screen Advanced Screen Advanced Screen
In this section, you may set the configurations for the following items: CPU Configuration,
Chipset Configuration, ACPI Configuration, IDE Configuration, PCIPnP Configuration,
Floppy Configuration, SuperIO Configuration, and USB Configuration.
Advanced
Main Smart
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.

CPU Configuration

Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.4.1 3.4.1 CPU Configuration 3.4.1 CPU Configuration CPU Configuration CPU Configuration
3.4.1 3.4.1 CPU Configuration
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Strap FSB to MCH
Boot Failure Guard
Spread Spectrum
Ratio Status Unlocked (Min:06, Max:11)
Ratio Actual Value
Ratio CMOS Setting
Enhanced Halt State
CPU Thermal Throttling
Hyper Threading Technology
Intel (R) SpeedStep (tm) tech.
Intel (R) C-STATE tech
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
BIOS SETUP UTILITY
H/W Monitor Boot Security
Overclock Settings
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
BIOS SETUP UTILITY
Select the over clock
mode.
[Auto]
[266]
[100]
[Auto]
[Enabled]
[Auto]
11
Select Screen Select Screen
[11]
Select Item Select Item
+- +- Change Option Change Option
[Disabled]
F1 F1 General Help General Help
[Enabled]
F9 F9 Load Defaults Load Defaults
[Disabled]
F10 F10 Save and Exit Save and Exit
[Auto]
ESC ESC Exit Exit
[Disabled]
4 7 4 7 4 7
4 7 4 7
Exit