ASROCK P45X3 DELUXE - V1.0 User Manual page 19

Table of Contents

Advertisement

1. If you plan to install only one PCI Express VGA card on this
motherboard, please install it on PCIE2 slot (Blue). In this mode,
you do not need to adjust the default setting of ASRock SLI/XFire
Switch Card, and please do not remove or lose ASRock SLI/XFire
Switch Card when it is still in working condition.
2. For the information of the compatible CrossFireX
Express VGA cards and CrossFireX
to "CrossFireX
Installing an expansion card
Installing an expansion card
Installing an expansion card
Installing an expansion card
Installing an expansion card
Step 1.
Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
Step 2.
Remove the system unit cover (if your motherboard is already installed in a
chassis).
Step 3.
Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
Step 4.
Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 5.
Fasten the card to the chassis with screws.
Step 6.
Replace the system cover.
setup procedures, please refer
TM
Operation Guide" on page 20.
TM
1 9
1 9
1 9
1 9
1 9
Mode PCI
TM

Advertisement

Table of Contents
loading

This manual is also suitable for:

P45x3 deluxe

Table of Contents