ASROCK N68C-GS UCC User Manual page 36

Processor Maximum Frequency
It will display Processor Maximum Frequency for reference.
North Bridge Maximum Frequency
This option appears only when you adopt Phenom CPU. It will display North
Bridge Maximum Frequency for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is
recommended to keep the default value for system stability.
BIOS SETUP UTILITY
Main OC Tweaker Advanced
EZ Overclocking
Load Optimized CPU OC Setting
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Boot Failure Guard
CPU/LDT Spread Spectrum
PCIE Spread Spectrum
SATA Spread Spectrum
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Multiplier
Processor Voltage
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for system stability, it is not recommended to ad-
just the value of this item.
Processor Voltage
This option appears only when you adopt AM2 CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for safety and system stability, it is not recom-
mended to adjust the value of this item.
CPU Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for
safety and system stability, it is not recommended to adjust the value of this
item.
H/W Monitor Boot Security
Overclocking may cause
[Press Enter]
damage to your CPU and
motherboard.
It should be done at
your own risk and
[Auto]
expense.
[200]
[100]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
Select Screen
Select Item
x10.5 2100 MHZ
Enter Go to Sub Screen
1.2500 V
F1 General Help
[Manual]
F9 Load Defaults
[x10.5 2100 MHz]
F10 Save and Exit
[1.2500 V]
ESC Exit
3 6 3 6 3 6 3 6 3 6
Exit