Oc Tweaker Screen - ASROCK N68C-GS UCC User Manual

3.3 3.3 OC T 3.3 OC T OC T OC Tweak weak weaker Screen weak er Screen er Screen er Screen
3.3 3.3 OC T weak er Screen
In the OC Tweaker screen, you can set up overclocking features.
Main OC Tweaker
EZ Overclocking
Load Optimized CPU OC Setting
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Boot Failure Guard
CPU/LDT Spread Spectrum
PCIE Spread Spectrum
SATA Spread Spectrum
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
HT Bus Speed
HT Bus Width
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
EZ Overclocking
Load Optimized CPU OC Setting
You can use this option to load the optiomized CPU overclocking setting.
Configuration options: [Press Enter], [Default], [5% (2520MHz)] to [40%
(3360MHz)]. Please note that overclocking may cause damage to your
CPU and motherboard. It should be done at your own risk and expense.
CPU Configuration
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Configura-
tion options: [Auto], [CPU, PCIE, Sync.], [CPU, PCIE, Async.] and [Optimized].
CPU Frequency (MHz)
Use this option to adjust CPU frequency.
PCIE Frequency (MHz)
Use this option to adjust PCIE frequency.
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
CPU/LDT Spread Spectrum
This feature will be set to [Enabled] as default. Configuration options:
[Disabled] and [Enabled].
PCIE Spread Spectrum
This feature will be set to [Enabled] as default. Configuration options:
[Disabled] and [Enabled].
SATA Spread Spectrum
This feature will be set to [Enabled] as default. Configuration options:
[Disabled] and [Enabled].
BIOS SETUP UTILITY
Advanced H/W Monitor Boot
Overclocking may cause
[Press Enter]
damage to your CPU and
motherboard.
It should be done at
your own risk and
[Auto]
expense.
[200]
[100]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
x10.5 2100 MHZ
Enter Go to Sub Screen
1.2500 V
F1
[Auto]
F9
[Auto]
F10
[Auto]
ESC
3 5 3 5 3 5 3 5 3 5
Security Exit
Select Screen
Select Item
General Help
Load Defaults
Save and Exit
Exit