ASROCK K10N78M PRO User Manual page 45

Secure Virtual Machine
When this option is set to [Enabled], a VMM (Virtual Machine Architecture)
can utilize the additional hardware capabilities provided by AMD-V. The
default value is [Enabled]. Configuration options: [Enabled] and [Disabled].
Enhanced Halt State
C1E is an enhanced power saving state which is supported by AM2 dual core
and AM2+ multi-core processors. The processor will enter C1E power saving
state when both of its cores transition into the C1 state. The default value is
[Disabled]. Configuration options: [Enabled] and [Disabled].
L3 Cache Allocation
This option appears only when you adopt Phenom CPU. The default value
is [Auto]. Configuration options: [Auto], [BSP Only] and [All Cores].
Processor Maximum Frequency
It will display Processor Maximum Frequency for reference.
North Bridge Maximum Frequency
This option appears only when you adopt Phenom CPU. It will display North
Bridge Maximum Frequency for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is recom-
mended to keep the default value for system stability.
BIOS SETUP UTILITY
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
L3 Cache Allocation
Processor Maximum Frequency
North Bridge Maximum Voltage
Processor Maximum Voltage
Multiplier/Voltage Change
CPU Frequency Multiplier
CPU Voltage
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for system stability, it is not recommended to ad-
just the value of this item.
If AUTO, multiplier and
[Auto] voltage will be left at the
rated frequency/voltage. If
[200]
Manual, multiplier and
[100]
voltage will be set based
[Enabled]
on User Selection in Setup.
[Enabled]
[Enabled]
[Auto]
[Enabled]
[Disabled]
Select Screen Select Screen
[Auto]
Select Item Select Item
x11.5 2300 MHz
+- +- Change Option Change Option
x9.0 1800 MHZ
F1 F1 General Help General Help
1.2500 V
F9 F9 Load Defaults Load Defaults
[Manual]
F10 F10 Save and Exit Save and Exit
[x11.5 2300 MHZ]
ESC ESC Exit Exit
[1.2500 V]
4 5 4 5 4 5 4 5 4 5