Ide Configuration - ASROCK K10N78FULLHD-HSLI - R2.0 User Manual

RTC Alarm Power On
Use this item to enable or disable RTC (Real Time Clock) to power on the
system.
ACPI HPET Table
Use this item to enable or disable ACPI HPET Table. The default value is
[Disabled]. Please set this option to [Enabled] if you plan to use this
motherboard to submit Windows

3 . 3 . 4 IDE Configuration

3 . 3 . 4 3 . 3 . 4 IDE Configuration IDE Configuration IDE Configuration
3 . 3 . 4 3 . 3 . 4 IDE Configuration
BIOS SETUP UTILITY
Advanced
IDE Configuration
[Enabled]
Onboard IDE Controller
Onboard SATA Controller [Enabled]
SATA Operation Mode [non-RAID]
[Hard Disk]
IDE1 Master
IDE1 Slave [Not Detected]
SATAII_1 [Not Detected]
SATAII_2 [Not Detected]
SATAII_3 [Not Detected]
[Not Detected]
SATAII_4
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Onboard IDE Controller
Use this item to enable or disable the "Onboard IDE Controller" feature.
Onboard SATA Controller
Use this item to enable or disable the "Onboard SATA Controller" feature.
SATA Operation Mode
Use this item to adjust SATA Operation Mode. The default value of this option
is [non-RAID]. If you want to operate RAID function on SATA / SATAII HDDs,
please select [RAID]. Configuration options: [non-RAID], [AHCI] and [RAID].
* If you select [RAID] mode, SATA / SATAII HDDs can not be accessed until you finish
configuring RAID functions in NVIDIA BIOS / Windows RAID Utility.
* If you install OS on SATA / SATAII HDDs, please do not change the setting of this
item after OS installation.
* If you install SATA / SATAII device on eSATAII port and plan to make a floppy image
or use Ghost under DOS (Disk Operating System), please set this option to
[non-RAID].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will use
the "IDE1 Master" as the example in the following instruction, which can be
applied to the configurations of "IDE1 Slave" as well.
Vista certification.
® TM
Options
Disabled
Enabled
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
5 5 5 5 5 5 5 5 5 5