Advanced Screen; Cpu Configuration - ASROCK G41M-LE-H - V1.0 User Manual

3.4 Advanced Screen

3.4 3.4 Advanced Screen Advanced Screen Advanced Screen
3.4 3.4 Advanced Screen
In this section, you may set the configurations for the following items: CPU Configuration,
Chipset Configuration, ACPI Configuration, IDE Configuration, PCIPnP Configuration,
Floppy Configuration, SuperIO Configuration, and USB Configuration.
Advanced
Main Smart
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.

CPU Configuration

Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.4.1 CPU Configuration 3.4.1 3.4.1 3.4.1 3.4.1 CPU Configuration CPU Configuration CPU Configuration CPU Configuration
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Boot Failure Guard
Spread Spectrum
Ratio Status Unlocked (Min: 12, Max: 16)
Ratio Actual Value
Enhanced Halt State
Intel Virtualization tech.
CPU Thermal Throttling
No-Excute Memory Protection
Hyper Threading Technology
Intel (R) SpeedStep(tm) tech.
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Overclock Mode
Use this to select Overclock Mode. Configuration options: [Auto], [Manual]
and [Optimized]. The default value is [Auto]. If you select [Manual], Untied
Overclocking function is enabled. Please refer to page 26 for the details of
Untied Overclocking Technology. Therefore, you are allowed to adjust the CPU
frequency and PCIE frequency in the following two items.
BIOS SETUP UTILITY
H/W Monitor Boot Security
Options for CPU
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
BIOS SETUP UTILITY
Select the over clock
mode.
[Auto]
[200]
[100]
[Enabled]
[Auto]
16
[Disabled] Select Screen Select Screen
[Enabled]
Select Item Select Item
[Enabled] +- +- Change Option Change Option
[Disabled] F1 F1 General Help General Help
[Enabled]
F9 F9 Load Defaults Load Defaults
[Auto] F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
3 0 3 0 3 0
3 0 3 0
Exit