ASROCK A770DE User Manual page 42

North Bridge Maximum Frequency
This option appears only when you adopt Phenom CPU. It will display North
Bridge Maximum Frequency for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is
recommended to keep the default value for system stability.
BIOS SETUP UTILITY
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
L3 Cache Allocation
Advanced Clock Calibration
Processor Maximum Frequency
North Bridge Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Target Frequency
North Bridge Target Frequency
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for system stability, it is not recommended to ad-
just the value of this item.
Processor Voltage
This option appears only when you adopt AM2 CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for safety and system stability, it is not recom-
mended to adjust the value of this item.
CPU Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for
safety and system stability, it is not recommended to adjust the value of this
item.
CPU Voltage
This option appears only when you adopt Phenom CPU. It allows you to
adjust the value of CPU voltage. However, for safety and system stability,
it is not recommended to adjust the value of this item.
Select the over clock
mode.
[Auto]
[200]
[100]
[Auto]
[Enabled]
[Auto]
[Enabled]
[Disabled]
[Auto]
[Disabled]
Select Screen Select Screen
Select Item Select Item
x10.5 2100 MHZ
x9.0 1800 MHz +- +- Change Option Change Option
1.2500 V
F1 F1 General Help General Help
[Manual]
F9 F9 Load Defaults Load Defaults
x10.5 2100 MHZ
F10 F10 Save and Exit Save and Exit
x9.0 1800 MHz
ESC ESC Exit Exit
4 2 4 2 4 2 4 2 4 2