Table of Contents
Advertisement
2.8 Surround Display Feature
2.8 Surround Display Feature
2.8 Surround Display Feature
2.8 Surround Display Feature
2.8 Surround Display Feature
This motherboard supports Surround Display upgrade. With the external add-on
PCI VGA card and PCI Express VGA card, you can easily enjoy the benefits of
Surround Display feature.
2.9 Jumpers Setup
2.9 Jumpers Setup
2.9 Jumpers Setup
2.9 Jumpers Setup
2.9 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper
PS2_USB_PWR1
1_2
(see p.9 No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
JR1 JL1
(see p.9 No. 25)
Note: If the jumpers JL1 and JR1 are short, both the front panel and the rear panel
audio connectors can work.
Clear CMOS
(CLRCMOS1, 2-pin jumper)
(see p.9 No. 9)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short 2 pins on
CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after
you update the BIOS. If you need to clear the CMOS when you just finish
updating the BIOS, you must boot up the system first, and then shut it down
before you do the clear-CMOS action.
Setting
2_3
+5V
+5VSB
JR1
JL1
2-pin jumper
1 8
1 8
1 8
1 8
1 8
Description
Short pin2, pin3 to enable
+5VSB (standby) for PS/2
or USB wake up events.
Advertisement
Table of Contents
