Preparing And Using The Remote Control - CyberHome Cyber Home CH-DVD500 Owner's Manual

Preparing and Using the Remote Control

Installing the Batteries
If the remote control only operates when you get closer to the DVD Player, it may mean the batteries are weak.
Please replace the two batteries simultaneously with two new batteries (Size AAA, R03, 1.5V) of the same type.
Please note the positive (+) and negative (-) polarity shown inside the battery compartment on the remote.
1. Push down and then outwards to
remove the battery compartment cover.
Important Note about Batteries
When changing batteries, it is not recommended to use a mix old and new batteries or batteries of different
brands simultaneously.
If the unit will not be used for an extended length of time, it's wise to remove the batteries before storage.
The life of the batteries depends on the amount of usage. With typical use, a battery life of approximately 6
Operation of Remote Control
When using the control, please aim at the device's remote control sensor, located in the DVD
STANDBY
ON / OFF
2. Insert Batteries following polarity
marked inside compartment.
CH-DVD 500
30
OPEN / CLOSE
30
POWER
SETUP OPEN/CLOSE
TITLE MENU GOTO DISPLAY
PBC
MUTE SUBTITLE AUDIO ANGLE
PLAY STOP
ENTER
SLOW PAUSE
ZOOM PROG BOOKMARK RETURN
3
1 2 C
4 5 6 +10
7 8 9 0
REPEAT EFFECT INTRO
1/ALL A-B
6
3. Slide Cover back into place.
Quick Tips
Make sure no objects
are between the remote
and the player.
Similar remote controls
could interfere with the
function of the player.
Make sure not to store
the remote upside
down or with any
objects pressing on the
buttons - this could
drain the battery.